That's great news. Did you switch your main halyard to 3/8's or 7/16? On Fri, May 8, 2015 at 2:58 PM, Neil Gallagher via CnC-List < cnc-list@cnc-list.com> wrote:
> Kyle, > > I made the switch from wire to rope on my 35-1 without changing the > sheaves. Works fine, no sign of unusual wear. > > Neil Gallagher > Weatherly, 35-1 > Glen Cove, NY > > > > > On 5/8/2015 2:27 PM, Kyle Mello via CnC-List wrote: > > Hello, I have a 72 C&C 35 MK1 and I am looking fora advice on where to get > some replacement sheaves. I am switching to rope from wire halyards. I have > looked online and called Hall in my home town of Bristol without any luck. > > There are 3 sheaves that need to be replaced. See dimensions below. > > 2 larger sheaves are > 4.1" in diameter or 104 mm > center hole is 1/2" > thickness is 1/2" > > Small sheave (main sail) > 3.5" diameter > center hole is 3/8" > thickness is 7/16 > > As far as I can tell the boat was made in Canada by George Hinterholler. > > Any input would be helpful. > > -Kyle > > > _______________________________________________ > > Email address:CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the bottom > of page at:http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
