Guys,

 

As part of my spring maintenance, I’ve been going over the mast.  Yesterday, I 
was going to lubricate the masthead sheaves and found that one of them was bad. 
 I had replaced all of them about ten years ago.  The torlon bearings in one of 
sheaves have gone bad.  The sheave will barely turn and it feels like gravel 
inside instead of bearings.  I can’t remember where I picked them up, but I 
need a replacement.  These sheaves are 2 ¾” in diameter, ½” wide, and run on a 
½” shaft.

 

I’ve looked at Zephyrworks, but would like another sheave with bearings.  They 
are pretty friction free and don’t require any maintenance.   Google hasn’t 
been much help yet, but I thought someone on the list might have a source.

 

Thanks,

 

Jake

 

Jake Brodersen

“Midnight Mistress”

C&C 35 Mk-III

Hampton VA

 

 

_______________________________________________

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of 
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com

Reply via email to