Some of the ‘ACR / VSR / Combiners’ have minimum wire length and maximum size 
requirements to maintain a minimum resistance that the device sees.

From: Russ & Melody via CnC-List 
Sent: Monday, April 06, 2015 6:40 PM
To: cnc-list@cnc-list.com 
Subject: Re: Stus-List Ed Shillay's Wiring Diagramme

Hi Leslie,

Why would you max size a wire spec? 

I can't think of any practical situation where a little too big is not good and 
the shorter runs are better too.

        Cheers, Russ
        Sweet 35 mk-1


At 05:33 PM 06/04/2015, you wrote:

  minor addition, the charge current is limited by the recommended wiring 
between the banks.  From memory, a minimum length of 6 feet and maximum size of 
6 SWG.  (please check before using this info.) Leslie Phoenix C&C32 1983 


--------------------------------------------------------------------------------
_______________________________________________

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of 
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com

_______________________________________________

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of 
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com

Reply via email to