Tom, when I did Perceptions (85 33-II) hatches I used Lewmar Ocean series that deck mounted. The corners fitted the ones on the openings better than the Bomars I removed.
Paul Fountain Managing Director SeaSource Inc. Bookkeeping & IT Services. From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of O'Keeffe Thomas via CnC-List Sent: Friday, March 27, 2015 8:46 AM To: C&C List Subject: Stus-List New foredeck hatch The hatch repair shop (Hatchmasters) suggested that in my case I might be better of replacing my Bomar foredeck hatch instead of sending to him to rebuild. It was a good conversation and I appreciated his product knowledge shared honestly. So I purchased the closest Bomar model from the 1039 series. My issue is the old hatch sits on top of the deck, but the new one has a flange. To fit the flange plus Bomar's trim ring I need to enlarge the hole by 3/4 inch (3/8 each side). I decided to use a router and made a template. Tried that yesterday and found the deck is tough, with solid epoxy between the skins. The router basically bounced off. I did it from underneath because the hatch sits in a recess topside. I probably won't try that again as I couldn't the router. Before I hack up my deck and any body parts, checking with this group for comments or ideas? Thanks. Tom O'Keeffe Bridie Mae 1984 C&C 29-2 Douglaston, NY
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
