The only ratching open ended wrench I have expierience with is these from Sears.
http://m.sears.com/craftsman-4-pc-metric-open-end-ratcheting-wrench/p-00921937000P They worked fine but the downside was that you needed at least 60° (one flat) of rotation before the "ratcheting" action would work. If you don't have that much throw at the end of your wrench then you are screwed. They also only work in one direction so don't think you can flip them to get a half flat at a time. For this single job I would stick with traditional combo wrenches. Specialty tools are fun when you have space and when the tool fits a recurring job perfectly. Josh Muckley S/V Sea Hawk 1989 C&C 37+ Solomons, MD On Mar 9, 2015 10:13 AM, "David Knecht via CnC-List" <cnc-list@cnc-list.com> wrote: > I was at the boat yesterday and tried to take the heat exchanger off the > engine (Universal M4-30) so I could refurbish the seals and make sure it is > clean (http://www.pbase.com/mainecruising/heat_exchanger). One bolt came > off easily but the one on the starboard side is a challenge. I cannot get > a socket on it because something from the engine or transmission is > partially blocking frontal access. I found my wrench selection on board is > less than adequate and I need to upgrade. I tried with a short 1/2" open > end wrench and was able to get it on, but could not budge the bolt. I left > it sprayed with penetrant hoping that will loosen it. > > I looked at other wrench types to see what would be useful in this > situation and came upon this ratcheting wrench I had not seen before: > > http://www.amazon.com/Alden-Wrench-56038-Ratching-Open-End/dp/B002VEC9XE/ref=sr_1_1?s=hi&ie=UTF8&qid=1425909762&sr=1-1&keywords=alden+ratchet > > It looks like something useful to have on the boat as the clamping action > should work on both metric and SAE, it is stainless and it ratchets. Has > anyone tried something like this? > > The other type I am considering is the flex head ratcheting wrenches: > > http://www.amazon.com/Husky5-Pieces-SAE-Flex-Ratcheting-Wrench/dp/B00CBFVKT2/ref=sr_1_4?s=hi&ie=UTF8&qid=1425910197&sr=1-4&keywords=ratcheting+flex+wrenches > > Dave > > > Aries > 1990 C&C 34+ > New London, CT > > > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com