I have available the following:

1) two alloy Barient 26's (non-ST) for parts if any lister needs some.
Drums, pawls and springs NOT included.  Basically gear base and bearings.

2) one pair of alloy Barlow 26's (non-ST).  Some anodizing is chipped off
the base on each.

3) a pair of alloy Barient 22's (non-ST).  These are in very good
condition. 5 bolt pattern on base.  (Some 22's have 6)

4) One alloy Barient 28 (non-ST)

On the subject of winches, I replaced all of Touche's alloy winches with
stainless or chrome bronze for about $1100 off ebay and Craigslist.  That
was two each Barlow 28's and 26's and a pair of Barient 22's.

I personally like Barient winches.  While the newer Lewmars, etc. are nice,
the Barients seem to be well made.  Clean them; lube them; use them.

Dennis C.
Touche' 35-1 #83
Mandeville, LA

On Sat, Feb 21, 2015 at 8:34 AM, mike amirault via CnC-List <
cnc-list@cnc-list.com> wrote:

>  Bradley, Try the Australian Yacht winch Company for barient parts.
>
> _______________________________________________
>
> Email address:
> CnC-List@cnc-list.com
> To change your list preferences, including unsubscribing -- go to the
> bottom of page at:
> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
>
>
>
_______________________________________________

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of 
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com

Reply via email to