Tracy, Chesapeake Bay Rigging, a Navtec Certified Dealer quoted me $800 to rebuild my ram in 2007. The local hydraulics guy charged me $25 to change the O rings in both the ram and the manual pump, and pressure tested both to 4000# for me. He also advised me to stop using the transmission fluid used by the PO and switch to 10 weight, non-detergent oil. Still tight after 7 years.
Chuck Resolute 1990 C&C 34R Broad Creek, Magothy River, Md ----- Original Message ----- From: "Jean-Francois J Rivard via CnC-List" <cnc-list@cnc-list.com> To: cnc-list@cnc-list.com Sent: Wednesday, February 4, 2015 4:30:38 PM Subject: Re: Stus-List Navtec pump service on Upper Gulf Coast Hi Tracy, I have the guy for you: Rick Zern http://zernrigging.com/ he's a Navtec Certified Rigger. Rick is awesome, he's detail oriented, methodical, and very knowledgeable. Many of the guys on my lake (Lake Lanier in the Atlanta suburbs) fly him over to take care of their boats. He's J-boat racer and is familiar with rod rigging too (Kind or a rarity these days) He's located in Pensacola, Phone Number 850.261.4129 Tell him Francois from Atlanta / Lake Lanier sent you. Good Luck, Francois Rivard 1990 34+ "Take Five" Lake Lanier, Georgia _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
