I used a Dremel MultiMax with a Dremel MM610 flexible scraper blade to
remove some ports a couple months ago.  Much better than a manual tool.
However, those ports weren't the C&C type ports, just regular openeing
ports.

Dennis C.
Touche' 35-1 #83
Mandeville, LA

On Fri, Oct 3, 2014 at 4:17 PM, Tony Wroblewski via CnC-List <
cnc-list@cnc-list.com> wrote:

> Eric, after having done this job a couple of times, a multitool with a
> flat saw blade makes short work of the removal. Place the blade between the
> window and fiberglass and cut away. Removes very little gel coat if you're
> carefull.
>
> _______________________________________________
> This List is provided by the C&C Photo Album
>
> Email address:
> CnC-List@cnc-list.com
> To change your list preferences, including unsubscribing -- go bottom of
> page at:
> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
>
>
>
_______________________________________________
This List is provided by the C&C Photo Album

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page 
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com

Reply via email to