Rick,

It's a big panel and although I could always remove this one and glass over the 
hole, there's really no place to put a panel that big were it won't interfere 
with sheet bags, lockers or the aesthetics of the aft cabin. 

If possible, I was thinking of just making a custom block of a few gauges, an 
ignition switch, a glow plug button and a starter button.

I figure the only gauges I really need are fuel, temp and tach. 

Could even put the ignition, glow plug and starter inside the locker where I 
have the pull-stop. 

Could be so much more elegant looking. Especially with ivory or white dials on 
the gauges. 


All the best,

Edd

-------------------------------
Edd M. Schillay
Starship Enterprise
NCC-1701-B
C&C 37+ | City Island, NY
www.StarshipSailing.com
-------------------------------
914.332.4400  | Office
914.332.1671  | Fax
914.774.9767  | Mobile
-------------------------------
Sent via iPhone 5

On Feb 22, 2014, at 5:00 PM, "Rick Brass" <rickbr...@earthlink.net> wrote:

The Universal Admiral panel on my 38 is set into a rectangular hole in the 
bulkhead and held in place with 8 screws. Can’t you just move the existing 
panel to a new location and glass in the old opening?
 
Failing that, a Universal Admiral Panel is around $250 – I thought about 
upgrading my instruments when I installed the new bobtail engine in 2010, until 
I found out I already had the upgrade instrument panel. Can’t you just buy a 
new panel intended for use with your engine, install it, and fill in the old 
holes (assuming there are individual holes for the instruments, key switch, and 
assorted pushbuttons)?
 
Rick Brass
 
From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Edd Schillay
Sent: Saturday, February 22, 2014 4:08 PM
To: cnc-list@cnc-list.com
Subject: Re: Stus-List Engine Gauges -- Are the marine ones somewhat universal?
 
I would like to use the existing senders (I work hard to remain lazy).
 
So how would I test the resistance? Unhook the wires and check the ohms with my 
multimeter? Or can I test with them connected? 

 
All the best,
 
Edd
 
 
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com

Reply via email to