Jake
I have an almost identical setup for the Adler Barbour on Alianna. In your case, did the added Styrofoam insulation make a significant difference? Have you added any insulation around the sides or on the bottom of the icebox? I am considering adding polyurethane spray foam insulation.I wonder if drilling holes from inside out through the ice box to insert the nozzle would be a reasonable way to do that.would the foam trap water that could cause problems.how many cans would I need etc. ? _____ From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Jake Brodersen Sent: January 23, 2014 8:20 PM To: cnc-list@cnc-list.com Subject: Stus-List Installing Refrigeration on a C&C 35 Mk3 Doug, I put in a standard Adler-Barbour system. The compressor is in the port lazarette, attached to a small shelf if the forward portion of the locker (just to the left of the water heater). The lines go straight through the bulkhead into the ice box. The thermostat control is under the sink, attached to the side of the ice box. It doesn't get accessed often and is out of the way. If I had a "do over", it would be to get a slightly smaller freezer section. Mine is great for cruising, but takes up a lot of space that could be used for beer when racing. I have room for three full ice cube trays and two quarts of ice cream right now. I also added insulation to the top of the ice box (from the inside) by gluing Styrofoam to it. I used the kind with a metallic facing, so it doesn't get wet. Jake _____________________________________________ From: CnC-List [ <mailto:cnc-list-boun...@cnc-list.com> mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Doug Allardyce Sent: Wednesday, January 22, 2014 5:30 PM To: CnC- List Subject: Stus-List Installing Refrigeration on a C&C 35 Mk3 All, I'm in the process of updating a 1985 C&C 35 MK 3. One of my projects is installing a refrigeration unit. As I'm in the planning phase, I'm looking to hear from anyone who has already done an installation. I would be interested to know what unit was selected, and how it was installed. If anyone has pictures that would be great Doug Allardyce 1985 C&C 35 MK III "Bullet" Detroit ~~~~~~~~_/)~~~_/) ~~~~~~~~
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
