Alex,

I had a plastics shop make new upper bearings for Touche' from Delrin.  My only 
suggestion, make them thicker than original.  UHMW might also work.

I wouldn't worry about the elevation of the top of the rudder tube. It should 
be fine.

Dennis C.
Touche' 35-1 #83
Mandeville, LA






>________________________________
> From: Alex Giannelia <a...@airsensing.com>
>To: "cnc-list@cnc-list.com" <cnc-list@cnc-list.com> 
>Sent: Tuesday, July 2, 2013 5:58 PM
>Subject: Stus-List Re-installing Rudder Post etc CC 35-II
> 
>
>
>So, 
> 
>I am at the stage where I want to re-install my rudder an am looking for a bit 
>of advice.
> 
>The SS post goes up through an opening in the hull which is not continuoulsly 
>joined to the  2nd opening in the cockpit sole, so I was wondering if greasing 
>it will not only control friction, but also water ingression, as the entry 
>point is slightly above the waterline which changes when under sail, where we 
>sometimes bury the bottom of the transom.
> 
>Also, what appear to have been nylon washers both at the cockpit and the 
>outside hull side are worn beyond, I want to replace with delrin (acetal).  
> 
>Any suggestions?
> 
>ALEX GIANNELIA
> 
>CC 35-II (1974) WILL BE RENAMED
>ON THE HARD SINCE NOV. 2006
>Toronto Ontario
> 
> 
>_______________________________________________
>This List is provided by the C&C Photo Album
>http://www.cncphotoalbum.com
>CnC-List@cnc-list.com
>
>
>
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com

Reply via email to