So, I am at the stage where I want to re-install my rudder an am looking for a bit of advice.
The SS post goes up through an opening in the hull which is not continuoulsly joined to the 2nd opening in the cockpit sole, so I was wondering if greasing it will not only control friction, but also water ingression, as the entry point is slightly above the waterline which changes when under sail, where we sometimes bury the bottom of the transom. Also, what appear to have been nylon washers both at the cockpit and the outside hull side are worn beyond, I want to replace with delrin (acetal). Any suggestions? ALEX GIANNELIA CC 35-II (1974) WILL BE RENAMED ON THE HARD SINCE NOV. 2006 Toronto Ontario
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
