I'm planning to replace a set of clutches this weekend. The old ones are mounted on teak blocks and bolted with 1/4 inch bolts and backing plates. The holes were drilled right through the core with no epoxy. There does not seem to be any water intrusion, as the bottom of the teak block was covered in a sealant.
What is the best way/material to fill the old holes? A tube of 4200? Should I enlarge the holes before filling them? For the new clutches, is butyl rubber the way to go or would you over-drill and fill with epoxy? -- Joel 301 541 8551
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
