Gene Heskett skrev den 2013-08-18 20:37:
I can't just yet, until linuxcnc gets a newer 64bit kernel built with
RTAI
support so as to be able to run linuxcnc on it. That is being
actively
worked on. Projected about another 90 days. The difficulty seems to
be
that the 64 bit builds appear to add quite a few microseconds to the
IRQ
latency, and for linuxcnc that is about as close to a show stopper as
exists.
http://jaqque.sbih.org/kplug/apt-pinning.html
is it not possible to use pinning so ?
_______________________________________________
Help us build a comprehensive ClamAV guide: visit http://wiki.clamav.net
http://www.clamav.net/support/ml
