-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Internet Helpdesk Sent: Wednesday, November 03, 2004 8:58 PM To: ClamAV users ML Subject: Re: [Clamav-users] clamav-milter segfault
>> Is 0.80n any better? > > from 10/30/2004? Nope, sorry. >Dang. I'm going to have to eat my words. I went to run it (clamav-milter >.80n) under gdb and discovered it's not segfaulting anymore, it's running fine. > >I could swear on a stack of bibles that I was trying to use the very lastest clamav-milter snapshot (.80n) from CVS the >>last time I tried (yesterday night), but I must not have been.> > >-Troy Good news bad news time - running slackware 10.0 plus security patches and downloaded clamav CVS tonight. Configured as such: ./configure --enable-milter make make install Clamd comes up fine, clamav-milter now segmentations faults (even under gdb - although I have no experience with this so ...) Clamav-milter on 0.80 release edition starts fine on this system, however after a few hours, days it falls over with nary a reason why and /var/run/clamav/clmilter.sock is not cleaned up i.e. still exists. I upgraded to CVS to see if this would fix the problem but it would appear things for me have got worse. Clamav-milter -V gives ClamAV version devel-20041103, clamav-milter version 0.80o I am recompiling now with ./configure --enable-milter --enable-debug as specified in the clamav-milter man page. May be related to the above problem. Evan _______________________________________________ http://lists.clamav.net/cgi-bin/mailman/listinfo/clamav-users
