Do you have any idea I use clamav 0.60 redhat 9 avery think is ok but clamav can't register with dazuko
@vorbe dazuko-1.2.1-pre2]# ./example registered with Dazuko successfully set access mask successfully set scan path successfully @vorbe dazuko-1.2.1-pre2]# lsmod Module Size Used by Not tainted dazuko 13496 0 @vorbe dazuko-1.2.1-pre2]# ls /dev/da* /dev/dazuko @vorbe dazuko-1.2.1-pre2]# cat /proc/devices | grep dazuko 254 dazuko > Be gentle I'm a newbie to ClamAV. > > I built Clam for the 1st time over the weekend. Stubbling my way though, > but I got the daemon and freshclam working. > > I went to build the clamav-milter today, but nothing seems to happen. > > version: clamav-0.60 > redhat: v8.0 > gcc3: 3.0.4-2 > > I tried ... > make clean > export CC=gcc3 > ./configure --enable-milter > make > make install > > No errors occur. > The Config does indicate gcc3 would be used, but the libmilter/ lines all > say "no" > The make and make install are fine (no errors). Make enters the > clamav-milter directory, but says that there is nothing to do for `all'. > After checking the install, the rest of the files seem to be built > (clamscan, clamdscan, fleshclam), but not the milter. > > Any ideas? > John > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
