> Do you have any idea I use clamav 0.60 redhat 9 avery think is ok but clamav > can't register with dazuko > > @vorbe dazuko-1.2.1-pre2]# ./example > registered with Dazuko successfully > set access mask successfully > set scan path successfully > > @vorbe dazuko-1.2.1-pre2]# lsmod > Module Size Used by Not tainted > dazuko 13496 0 > > @vorbe dazuko-1.2.1-pre2]# ls /dev/da* > /dev/dazuko > > @vorbe dazuko-1.2.1-pre2]# cat /proc/devices | grep dazuko > 254 dazuko > > > > > Be gentle I'm a newbie to ClamAV. > > > > I built Clam for the 1st time over the weekend. Stubbling my way though, > > but I got the daemon and freshclam working. > > > > I went to build the clamav-milter today, but nothing seems to happen. > > > > version: clamav-0.60 > > redhat: v8.0 > > gcc3: 3.0.4-2 > > > > I tried ... > > make clean > > export CC=gcc3 > > ./configure --enable-milter > > make > > make install > > > > No errors occur. > > The Config does indicate gcc3 would be used, but the libmilter/ lines all > > say "no" > > The make and make install are fine (no errors). Make enters the > > clamav-milter directory, but says that there is nothing to do for `all'. > > After checking the install, the rest of the files seem to be built > > (clamscan, clamdscan, fleshclam), but not the milter. > > > > Any ideas? > > John > > > > > > > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] > > For additional commands, e-mail: [EMAIL PROTECTED] > > > > >
--------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
