Hi just tested and police rate x pps is only applicable to control plane Cheers
Il giorno mer 8 set 2021 alle ore 15:51 Lukasz Bromirski < [email protected]> ha scritto: > Saku is always on point ;) > > > On 8 Sep 2021, at 15:31, Saku Ytti <[email protected]> wrote: > > > > On Wed, 8 Sept 2021 at 16:30, Lukasz Bromirski <[email protected]> > wrote: > > > >>> 3) is there any mode to limit pps and not only bandwidth > >> > >> I no longer remember this from top of my mind, but there’s bunch of > good QoS/HQoS presentations about ASR 1000 in particular on ciscolive.com > that you can use as reference. > > > > police rate x pps > > Just checked this on 17.x based release (3k = 3000 for this example): > > rtr-edge(config-pmap-c)#police rate 3k ? > account Overhead Accounting > bps Treat 'rate' value in bits-per-second > burst Specify 'burst' parameter > conform-action action when rate is less than conform burst > cps Treat 'rate' value in cells-per-second > peak-rate Specify peak rate or PCR for single-level ATM 4.0 > policer policies > pps Treat 'rate' value in packets-per-second > <cr> <cr> > > -- > ./ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
