Saku is always on point ;) > On 8 Sep 2021, at 15:31, Saku Ytti <[email protected]> wrote: > > On Wed, 8 Sept 2021 at 16:30, Lukasz Bromirski <[email protected]> wrote: > >>> 3) is there any mode to limit pps and not only bandwidth >> >> I no longer remember this from top of my mind, but there’s bunch of good >> QoS/HQoS presentations about ASR 1000 in particular on ciscolive.com that >> you can use as reference. > > police rate x pps
Just checked this on 17.x based release (3k = 3000 for this example): rtr-edge(config-pmap-c)#police rate 3k ? account Overhead Accounting bps Treat 'rate' value in bits-per-second burst Specify 'burst' parameter conform-action action when rate is less than conform burst cps Treat 'rate' value in cells-per-second peak-rate Specify peak rate or PCR for single-level ATM 4.0 policer policies pps Treat 'rate' value in packets-per-second <cr> <cr> -- ./ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
