For XR - make sure you specify src addr in TPA context - tpa vrf abc address-family ipv4 update-source MgmtEth0/RP0/CPU0/0
Have not played with XE telemetry but I would check subsystem components: show platform software yang-management process HTH On Sat, Jun 20, 2020 at 3:43 AM Dave Bell <[email protected]> wrote: > A while back when I was experimenting this is the configuration I had > running on a CSR1k 16.12.0 > > netconf-yang > > telemetry ietf subscription 1 > encoding encode-kvgpb > filter xpath > /process-cpu-ios-xe-oper:cpu-usage/cpu-utilization/five-seconds > source-address 192.168.0.2 > stream yang-push > update-policy periodic 5000 > receiver ip address 10.0.2.1 57000 protocol grpc-tcp > > > Apart from the VRF statement that is exactly what you have. > > Coincidently I’m trying to get this working on IOS XR with no success. A > variety of versions, and I’m also having issues. I’m using the same config > I tested a while back, but as with you I’m trying to source it in a VRF. > > I’ve got a TAC case open, however I’ve got a feeling it’s going to come > back as unsupported. > > On Sat, 20 Jun 2020 at 06:42, Robert Hass <[email protected]> wrote: > > > Yes I did > > > > #sh run | inc netconf > > netconf-yang > > > > #show platform software yang-management process > > confd : Running > > nesd : Running > > syncfd : Running > > ncsshd : Running > > dmiauthd : Running > > nginx : Running > > ndbmand : Running > > pubd : Running > > gnmib : Not Running > > > > On Sat, Jun 20, 2020 at 12:02 AM Dave Bell <[email protected]> wrote: > > > >> Have you enabled netconf-yang? > >> > >> On Fri, 19 Jun 2020 at 20:46, Robert Hass <[email protected]> wrote: > >> > >>> Hi > >>> I'm trying to run telemetry on IOS XE (Catalyst 9300) but without lack. > >>> > >>> My config: > >>> > >>> test#sh run | sec tele > >>> telemetry ietf subscription 1 > >>> encoding encode-kvgpb > >>> filter xpath > >>> /process-cpu-ios-xe-oper:cpu-usage/cpu-utilization/five-seconds > >>> source-address 10.0.0.147 > >>> source-vrf Mgmt-vrf > >>> stream yang-push > >>> update-policy periodic 500 > >>> receiver ip address 10.0.3.16 12345 protocol grpc-tcp > >>> > >>> But it's not working: > >>> #show telemetry ietf subscription all > >>> The process for the command is not responding or is otherwise > unavailable > >>> > >>> Any ideas ? > >>> > >>> Running IOS XE 17.02.01 > >>> > >>> Rob > >>> _______________________________________________ > >>> cisco-nsp mailing list [email protected] > >>> https://puck.nether.net/mailman/listinfo/cisco-nsp > >>> archive at http://puck.nether.net/pipermail/cisco-nsp/ > >>> > >> > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
