Yes I did #sh run | inc netconf netconf-yang
#show platform software yang-management process confd : Running nesd : Running syncfd : Running ncsshd : Running dmiauthd : Running nginx : Running ndbmand : Running pubd : Running gnmib : Not Running On Sat, Jun 20, 2020 at 12:02 AM Dave Bell <[email protected]> wrote: > Have you enabled netconf-yang? > > On Fri, 19 Jun 2020 at 20:46, Robert Hass <[email protected]> wrote: > >> Hi >> I'm trying to run telemetry on IOS XE (Catalyst 9300) but without lack. >> >> My config: >> >> test#sh run | sec tele >> telemetry ietf subscription 1 >> encoding encode-kvgpb >> filter xpath >> /process-cpu-ios-xe-oper:cpu-usage/cpu-utilization/five-seconds >> source-address 10.0.0.147 >> source-vrf Mgmt-vrf >> stream yang-push >> update-policy periodic 500 >> receiver ip address 10.0.3.16 12345 protocol grpc-tcp >> >> But it's not working: >> #show telemetry ietf subscription all >> The process for the command is not responding or is otherwise unavailable >> >> Any ideas ? >> >> Running IOS XE 17.02.01 >> >> Rob >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
