Hi Arie,
That's what I also stumbled upon but I noticed it says that MPLSoMGRE
should be supported but then I only spot p2p Tunnel interfaces and I'm
not sure if some small detail escapes my site or how I can configure a
multipoint tunnel interface:)
That would be step one and step 2 figuring out the route-map equivalent
that would then build a tunnel to the nexthop received as it was the
case with IOS XE.
Have a feeling that I will get some headaches along the way..this is not
really a very detailed/documented topic.
On 2018-05-17 00:02, Arie Vayner wrote:
Mihai,
Try checking this document:
https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r6-1/lxvpn/configuration/guide/b-l3vpn-cg-asr9k-61x/b-l3vpn-cg60xasr9k_chapter_0100.pdf
I have a feeling this will require a bit trial and error, but this
seems to be the right direction.
On Wed, May 16, 2018 at 2:57 PM <[email protected]> wrote:
Hi guys,
I'm trying something strange and funky in a lab and of course ending
up
at a dead-end :)
I'm trying to configure OpenContrail to peer with ASR9K.
I've already found a sample configuration for ASR903 but that one
has
IOS XE.
Does anyone know if there is an equivalent for the following
commands on
IOS XR?
So far I can't find anything and am knocking my head against the
wall a
bit (I did find that MGRE should be supported though and MPLS over
it).
l3vpn encapsulation ip MGRE
transport ipv4 source GigabitEthernet0/4/7
route-map SELECT_UPDATE_FOR_L3VPN permit 10
set ip next-hop encapsulate l3vpn MGRE
Thanks in advance,
Mihai
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
