Mihai, Try checking this document: https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r6-1/lxvpn/configuration/guide/b-l3vpn-cg-asr9k-61x/b-l3vpn-cg60xasr9k_chapter_0100.pdf
I have a feeling this will require a bit trial and error, but this seems to be the right direction. On Wed, May 16, 2018 at 2:57 PM <[email protected]> wrote: > Hi guys, > > I'm trying something strange and funky in a lab and of course ending up > at a dead-end :) > > I'm trying to configure OpenContrail to peer with ASR9K. > I've already found a sample configuration for ASR903 but that one has > IOS XE. > > Does anyone know if there is an equivalent for the following commands on > IOS XR? > So far I can't find anything and am knocking my head against the wall a > bit (I did find that MGRE should be supported though and MPLS over it). > > l3vpn encapsulation ip MGRE > transport ipv4 source GigabitEthernet0/4/7 > > route-map SELECT_UPDATE_FOR_L3VPN permit 10 > set ip next-hop encapsulate l3vpn MGRE > > Thanks in advance, > Mihai > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
