It¹s not needed.
"address-family vpnv4" section is used to define which routers participate in the VPNv4. The underlying MPLS network will forward labels between the VPNv4 end-point CE's. Next-hop-self isn¹t required. All that¹s required is MPLS and IGP reachability between the CE¹s participating in the vpnv4 domain. On 19/09/2014 10:31 am, "CiscoNSP List" <[email protected]> wrote: >Is it recommended to add it under vpnv4 also? > >i.e. > >router bgp xxxxxx >... >neighbor iBGP-IPv4-PEERS update-source Loopback0 >neighbor iBGP-IPv4-PEERS next-hop-self >neighbor xxx.xxx.xxx.xxx peer-group iBGP-IPv4-PEERS... >address-family vpnv4 > bgp redistribute-internal > neighbor iBGP-IPv4-PEERS send-community extended > neighbor iBGP-IPv4-PEERS next-hop-self > neighbor xxx.xxx.xxx.xxx activate > >Cheers. > > > >_______________________________________________ >cisco-nsp mailing list [email protected] >https://puck.nether.net/mailman/listinfo/cisco-nsp >archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
