Same here, I do not recall any tabs.
Scott H.
On 9/11/14, 11:16 AM, Mike Hale wrote:
You should just be able to pull it out...I don't think there's a tab
since it's held in place with the two screws. I don't remember any
tabs on the ones I've removed.
On Thu, Sep 11, 2014 at 7:54 AM, Scott Granados <[email protected]> wrote:
Carefully as apposed to what, recklessly press the tab with a hammer?
;)
On Sep 11, 2014, at 10:12 AM, Drew Weaver <[email protected]> wrote:
In the instructions for removing a network module from a 3560x it states
'carefully press the tab on the right side of the module'.
I can't seem to locate a tab on the NM-10G which releases it from the slot.
Is it under the mounting bracket? Under the faceplate? Is anyone aware of where
this mythical tab resides?
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
