for some reason i seem to remember that if you have the i/o modules with console in them that it disables the onboard console on the g1/g2 engines..
Been a while since i've touched one of these though. On Wed, Aug 27, 2014 at 9:12 AM, Scott Granados <[email protected]> wrote: > If you have the old 25 pin mod tap that comes with the console cables you > can use that which converts you to RJ45 and then you can use your normal 9 > pin on the other end. Else you need a regular null modem type cable which > are readily available. As someone else mentioned, if you’re using a G1 or > G2 there should be an RJ45 console port as well. > > On Aug 27, 2014, at 6:27 AM, Mohammad Khalil <[email protected]> wrote: > > > Hi all > > I have old Cisco VXR I need to access with console , but it's not RJ45 > console , it's like the computer ports > > is there a specific cable to use? > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
