James, is this a Q-in-Q with those two vlans encapsulated inside a vlan 1048 tag. Also check the MTU, te be able to carry Q-in-Q you will need to set it to 1512 or greater for the extra tag overhead.
On Fri, Aug 8, 2014 at 12:17 PM, james edwards < [email protected]> wrote: > I am trying to configure an interface on a ME3600 to accept Q in Q > from a provider. The p-vlan the provider is using is 1048 and they are > carrying customer vlans (c-vlan) 1058-1098, one from each site. I'm > new to the 3600 and have not done Q in Q on it yet. I've worked up > this much of the config but it does not seem right. Can anyone give me > some pointers or links to help me along ? I've only got one customer > site configed, there will be 14. > > > ! > vlan 1048 > name WINDSTREAM > ! > vlan 1058 > name WINDSTREAM-HOBBS > ! > interface GigabitEthernet0/6 > description Windstream VLS IP.LVXX.xxxxxx..WCI.001 > port-type nni > switchport trunk allowed vlan none > switchport mode trunk > service instance 10 ethernet > encapsulation dot1q 1048 > rewrite ingress tag pop 1 symmetric > bridge-domain 10 > ! > ! > interface Vlan1048 > description Windstream VLS > no ip address > ! > interface Vlan1058 > description WINDSTREAM-HOBBS > ip address xxx.xx.xx.1 255.255.255.0 > > > > Thanks, > > James > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > -- Brian Christopher Raaen Network Architect Zcorum _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
