Hi All
I have got the issue where I am unable to configure management access to the
ME3600 Switch. The switch is currently on customer site and it has got only one
uplink back to service provider network and one downstream link to customer
switch. I have got following configuration on the Uplink to service provider:
interface GigabitEthernet0/13 port-type nni switchport trunk allowed vlan none
switchport mode trunk mtu 1504 service instance 25 ethernet encapsulation
dot1q 100 second-dot1q 200,433,472 rewrite ingress tag pop 1 symmetric
bridge-domain 25 As you can service VLAN is 100 and it gets stripped off before
sending C-VLANs to customer switch. The following configuration is on the port
connecting to customer switch: interface GigabitEthernet0/19 port-type nni
switchport trunk allowed vlan none switchport mode trunk mtu 1504 service
instance 26 ethernet encapsulation dot1q 200,433,472 bridge-domain 25 I have
tested the customer VLANs and I can ping successfully from service provider to
Customer Equipment. However, issue I am having is that due to only one uplink
to service provider, I am unable to configure interface VLAN (SVI) within the
bridge domain. I have tried configuring interface VLAN 25 (bridge domain 25)
but that didn't work. Have you guys got any other ideas ? Any !
help would be appreciated Thanks in Advance Sikandar
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
