I'm getting ready to do an upgrade from a 7204VXR with 6 GigE interfaces to an ASR 1002-X, basically one for one interfaces and configuration.
Is there anything I need to watch out for, either hardware-wise or software-wise when moving the configuration? (other than the typical nomenclature/interface designations and small syntactical changes, that is) Any recommendations for code version on the ASR? 7200VXR is running c7200-pk9u2-mz.124-25c I'm ordering the ASR with AIP and 8 GB RAM The interface configuration is one downstream switch (1 Gbps @150+Mbps), one Internet upstream (full bgp), one peering fabric connection, two remote circuits (200Mbps) I'm probably turning the 7200VXR into a ibgp route reflector - any opinions about that? thanks -e- _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
