Hi Does you link on ethernet go down ???? If you got layer 2 switch in between, the link does not go down, it will stay up.
You can use ip sla to detect the neighbor is down. Jey S. Network Engineer Sent from my iPhone > On 3 Dec 2013, at 07:50, M K <[email protected]> wrote: > > Hi Oliver :)My config is so simpleR1 - R2 - R3 > R2 is configured with a static route pointing to R1 (external network)ip > route 0.0.0.0 0.0.0.0 192.168.12.1I configured an access-list matches the > link between R1 and R2R2access-list 1 permit 192.168.12.0 0.0.0.255route-map > MAP permit 10match ip address 1 > router ospf > default-information originate always route-map MAP > Now , when I turn off the interface from R1 side , R3 no longer receives the > default route when I used a serial connectionWhen I used Ethernet , the > default route still appears on R3 routing table > I can use another way such as EEM but I want to understand this behavior > BR, >> From: [email protected] >> To: [email protected]; [email protected] >> Subject: Re: [c-nsp] OSPF Conditional Inject >> Date: Tue, 3 Dec 2013 06:36:39 +0000 >> >> >> >>> Hi I was working on a setup to test the OSPF conditional injection of a >>> default routeIt worked me fine for Serial connection , but for Ethernet >>> media it did not why ? >> >> because you didn't share the config? ;-) >> >> oli > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
