Hi Oliver :)My config is so simpleR1 - R2 - R3
R2 is configured with a static route pointing to R1 (external network)ip route
0.0.0.0 0.0.0.0 192.168.12.1I configured an access-list matches the link
between R1 and R2R2access-list 1 permit 192.168.12.0 0.0.0.255route-map MAP
permit 10match ip address 1
router ospf
default-information originate always route-map MAP
Now , when I turn off the interface from R1 side , R3 no longer receives the
default route when I used a serial connectionWhen I used Ethernet , the default
route still appears on R3 routing table
I can use another way such as EEM but I want to understand this behavior
BR,
> From: [email protected]
> To: [email protected]; [email protected]
> Subject: Re: [c-nsp] OSPF Conditional Inject
> Date: Tue, 3 Dec 2013 06:36:39 +0000
>
>
>
> >Hi I was working on a setup to test the OSPF conditional injection of a
> >default routeIt worked me fine for Serial connection , but for Ethernet
> >media it did not why ?
>
> because you didn't share the config? ;-)
>
> oli
>
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
