>Hi Randy >I know what the variance command does and know how to manipulate >I was challenged to do what I asked without using any filtering or touch the >variance command configured > > >> Date: Fri, 29 Nov 2013 14:35:22 -0800 >> From: [email protected] >> Subject: Re: [c-nsp] EIGRP Variance >> To: [email protected]; [email protected] >> >> ----- Original Message ----- >> >> > From: M K <[email protected]> >> > To: "[email protected]" <[email protected]> >> > Cc: >> > Sent: Friday, November 29, 2013 1:55 PM >> > Subject: [c-nsp] EIGRP Variance >> > >> > Hi I have two unequal cost paths to reach a specific destinationI >> > configured >> > variance and the two routes are installed in the routing tableHow can I >> > use the >> > low cost always with keeping the other one installed in the routing table ? >> >> >> If I understand you correctly: >> You have enabled unequal-cost load sharing via variance but *don't wish* to >> load share. >> >> Does that make any sense to you? >> >> Disable variance, lowest cost path will be in rib and EIGRP topology db will >> have both - tweak delay if needed so the *other* exists as a feasibel >> successor. >> ./Randy
...an exam eh! consider metric-weights. (load/reliability) - don't do this in production. ./Randy _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
