Hi, Im trying to do this on Version 15.3(3)S but the xconnect is rejected if I enable l2protocol forward.
Which version are you succesfully doing this on? (config-if-srv)# l2protocol forward (config-if-srv)#xconnect x.x.x.x 1730 encapsulation mpls Layer2 protocol tunnel/forward/peer configured. Command rejected /F On 18 November 2013 19:43, Pshem Kowalczyk <[email protected]> wrote: > Hi, > > The only way we could get the L2 forwarding going on ASR901 was using > a single service instance with encapsulation default (this only works > in newest software): > > interface GigabitEthernet0/8 > no ip address > negotiation auto > no keepalive > service instance 1 ethernet > encapsulation default > l2protocol forward > xconnect 10.123.129.3 34322 encapsulation mpls > mtu 9000 > > > kind regards > Pshem > > > On 19 November 2013 02:11, Fredrik Vöcks <[email protected]> > wrote: > > Hi all, > > > > We are having a customer who says he can't forward BPDU packets over an > > portbased EoMPLS using an ASR 901. > > > > Is this something known or am I missing something? Relevant > configuration; > > > > interface TenGigabitEthernet0/1 > > description c_customer433231 > > no keepalive > > xconnect x.x.x.x 1730 encapsulation mpls > > > > /F > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
