Routing is enabled on that router and I do have bridge irb enabled just to be safe.
On Nov 12, 2010, at 6:07 PM, "John Neiberger" <[email protected]> wrote: > On Fri, Nov 12, 2010 at 3:40 PM, Todd Shipway > <[email protected]> wrote: >> >> The issue is that no traffic will pass over the bridge. Router1 is unable >> to ping router2 and vice versa. Any ideas as to what I'm missing with this? > > It's been forever since I've played with serial bridging, but I seem > to recall that unless you have IRB configured, you have to disable IP > routing in order to bridge IP. Do you have IP routing disabled on the > router that's acting as a bridge? If you need to have IP routing > turned on, I believe you need to configure integrated routing and > bridging. > > I may be wildly wrong, so take this with a grain of salt. :) > > John _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
