On Fri, Nov 12, 2010 at 3:40 PM, Todd Shipway <[email protected]> wrote: > > The issue is that no traffic will pass over the bridge. Router1 is unable to > ping router2 and vice versa. Any ideas as to what I'm missing with this?
It's been forever since I've played with serial bridging, but I seem to recall that unless you have IRB configured, you have to disable IP routing in order to bridge IP. Do you have IP routing disabled on the router that's acting as a bridge? If you need to have IP routing turned on, I believe you need to configure integrated routing and bridging. I may be wildly wrong, so take this with a grain of salt. :) John _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
