On 2021-Jun-26, at 10:15 AM, Paul Koning via cctalk wrote:
>> On Jun 26, 2021, at 11:31 AM, Tapley, Mark B. via cctalk 
>> <cctalk@classiccmp.org> wrote:
>> 
>> At one point FTDI had a reasonably good reputation, and I own one of those 
>> devices based on that reputation. I have used it with no obvious problems 
>> connecting a TRS Color Computer 3 to an iMac G3 for a floppy-drive emulator 
>> (DriveWire on the iMac), but I think only for that application so far.
>> 
>> Are there any particular pitfalls I should watch out for with the FTDI 
>> device, when/if I can get back to working with it?
> 
> I once bought a USB serial port device with a DE-9 connector on it, Belkin I 
> think.  It worked somewhat.  Might have needed its own driver, which on a Mac 
> is highly unusual.  It gave me enough trouble I set it aside.
> 
> Since then I've bought several different flavors of the FTDI USB serial 
> device, one RS-232, one 5 volt logic, one 3.3 volt logic (the latter two with 
> 6-pin connectors to fit onto pin headers such as are found on the BeagleBone 
> Black).  They have always worked flawlessly (on my Mac), at a number of data 
> rates: 4800, 9600, 19.2k, 115k.  I'll admit I haven't needed stranger cases 
> like 5 or 6 bit data, or exotic slow speeds.  As I mentioned, if that need 
> arises and FTDI isn't good enough I'll have the RPico to do the job.

A couple years ago, somewhat on a whim, I checked a small number of USB-Serial 
converters for driving a couple of Model 28 Teletypes.

I didn't really expect anything so modern to work below 300 BPS, or do the 
needed 5-data/2-stop, but the teletypes were 75 BPS, which is just another in 
the division-of-2 series down from 19200,9600,etc.; and I was actually figuring 
on just using 8-bit and ensuring the later bits were 0 so they would be seen as 
stop bits, and take a bit of a penalty on the 28 print speed (might be a little 
rough/abusive on the teletype commutator start/stop though).

Sometimes, ya luck out: one of them actually worked down to 75 BPS, *and* did 
5-data/2-stop.

There's no ID on the physical unit but it shows up on the system (OSX) as: 
        Product ID: 0x2303
         Vendor ID: 0x067b  (Prolific Technology, Inc.)

(Product ID 0x2303: Prolific produces a series of PL2303x USB-Serial chips.)

It was plug-n-play on the Mac (given a terminal app program that knows to 
accept and perform the little-used config specs).

There are some other teletypes to get going that need slower speeds, for which 
I intend a solution as (Paul) suggests, bit-banging out of an RPi. The code was 
written some time ago, but haven't gotten around to the physical connections.

Reply via email to