Paul,
You are entirely correct when it comes to temperature. Even ten or
20 degrees F can severely shorten the life of a HDD. It looks like I
will be getting HGST drives even though I have had some difficulties
with them.
GOD Bless and Thanks,
rich!
I don't have much to offer; my experience with enterprise class HDDs is mostly SAS
(unless you go way back over 10 years). I didn't even know that such a thing as
"enterprise class SATA" exists.
One caution: I can't point to any manufacturer as "always good" or "always
bad". The reality is that drive design is an incredibly hairy job, and small issues can
appear in a given model to mess up the reliability of a particular design. Sometimes those design
issues don't appear until some time after release.
In other words, the fact that brand X has really good 4 TB drives doesn't
necessarily tell you much about their 8 TB drives. Conversely, if brand Y had
a bad implementation of 3 TB drives, that probably doesn't carry over to later
models (not even later models in the same size, let alone in different sizes).
If you run your drives in a well cooled enclosure, that will help. I've seen
some drives that became problematic when run at the high end of their
temperature specs, as might happen in high powered servers or in storage arrays
with lots of drives in a small enclosure. Some failure modes are related to
temperature, and if your drives are well below the spec limit that will help.
Conversely, do pay attention to HDD temperature specs. Those numbers should be
taken seriously. A lot of electronics can be run moderately over temperature
without serious consequences, but the mechanics of hard drives are often far
less forgiving.
paul