Paul, Jerry,
Thanks for the suggestion to take a look at DataTranslation!
Looking in the bitsavers folder for DataTranslation, I found a 239 page
July 1986 Data Translation manual for the DT3362 series of A/Ds. There are 23
sub-models of that board but the DT3362-16SE/8DI specifications matches the
ADV11-D (A1008).
The best part is that chapter 8 of this manual has 5 programming examples,
two of which use the DMA capability.With a bit of research (and some luck) I
think this will give me the info I need.
Thanks again,
Mark
Date: Sat, 17 Oct 2020 02:06:25 -0500
From: Paul Anderson <used...@gmail.com>
I think they were made by Data Translation.
On Fri, Oct 16, 2020 at 8:00 PM Jerry Weiss via cctech <
cct...@classiccmp.org> wrote:
>
> I just picked a AAV11-D D/A Board for which documentation is also
> scarce. The general design may be similar. I should be able to reverse
> engineer the analog/digital output section for pin-outs. Lacking
> manuals/source code, if someone has an existing driver or software in
> binary, I would be willing to disassemble that for its secrets. Perhaps
> these boards mimic the methods used by ADAC or Data Translation used for
> their Qbus products. Their documentation may also give some insight on
> how to setup these CSR's.
>
> Regards,
> Jerry
>
