On 4/11/2018 4:16 PM, Torfinn Ingolfsen via cctalk wrote:
Since you brought it up

On Wed, Apr 11, 2018 at 11:48 PM, ben via cctalk <cctalk@classiccmp.org> wrote:


The FREE fpga development software is only under windows.


Free alternatives exist (and can only get better coverage with time)
http://www.clifford.at/yosys/
https://github.com/cseed/arachne-pnr
http://www.clifford.at/icestorm/

HTH


Does NOT support my FPGA. I am using the FPGA for all the heavy lifting
of testing my cpu design so in time it can be used for other things. The real design is a microcode 2901 cpu about 1976 ish, with 256x8 70 ns proms. Modern 22V10's will be used as 'prom' and 'glue' logic, but alas that software and GAL programmer still are windows only.

It is a similar feel to the 16 bit computers other than the PDP 11,
and same cycle times as core of that era. 1.3 us for operate and 2.6 us memory operations. 18 bits is just about right for a 'small' computer size and operands and front panel. Disk I/O will be fake devices of 9 bit characters on a SD card.

Now I need to hit the web for some good programing books from the
1970's era so I finalize the I/O and memory map of the computer and
fine tune the instruction set.

Ben.
Yes I know the FPGA card can run faster,but not with 1976 speeds.












Reply via email to