Is there a potential problem here?

I have an 11/53 microPDP11 with a RQZX1 controller connected to a single DEC DSP3043 drive (535MB) and a single RX33 floppy.

The autoconfigure setup in the RQZX1 puts the hard disk at DU0 and the Floppy as DU1.  OK.  I boot RT11 from the disk, V5.7. Works fine.

I would like to use some of the extra space on the disk by setting up RT11 disk partitions.

However, one of the partitions is DU1, but that is what the Floppy is called.  How do I stay away from what seems like a conflict?

Doug

Reply via email to