Hi all...I am hoping there is someone here who has an 11/40 or 11/35 and a M9312 ROM terminator card. I'd like to know how you have yours jumpered.
I took photos of the jumpers installed in my M9312: http://www.vintagecomputer.net/digital/PDP11-40/M9312/ Here is the page from the manual that describes jumpers per UNIBUS system type: http://www.vintagecomputer.net/digital/PDP11-40/M9312/M9312_Jumper-configurations.JPG 1) Yes or no - Did I correctly identify the location of W8? 2) Yes or no - Should W8 be in for am 11 40/25/10/05 or is the /40 special? Here is the issue....when I jumper W8 the CPU can do very little and I cannot activate the CONSOLE ROM. I put in posts into what I believe is W8 so I can switch back and forth without having to re-solder. With W8 out the system works better, and I can at least get to the CONSOLE prompt. Looking for opinions as to whether my card is correctly configured. I am trying to determine why I can't bootstrap and run a TU58 nor RL11, yet I can load and run BASIC just fine. I think I may have a UNIBUS problem OR a CPU card problem, but I can't load XXDP either to determine for sure. There are more problems, I can't bootstrap the RL11 nor TU58 manually either, I am working through everything CPU and UNIBUS too. Is there a complete XXDP tape that I can download from PDPGUI? I found TU58 image but I can't get the TU58em emulator to work yet. If I could just figure out why I can load BASIC and not RL02 RT11 I'd make my day. Thanks Bill
