> -----Original Message----- > From: cctalk [mailto:[email protected]] On Behalf Of tony duell > Sent: 25 June 2016 16:49 > To: [email protected]; General Discussion: On-Topic and Off-Topic Posts > <[email protected]> > Subject: RE: VR241 Stray Wire > > > You can see the wire in question at the bottom of the picture below, > > it is the green wire with a single-pin connector on it, and the size > > link connector is the two-pronged connector just below it in the photo: > > > > https://1drv.ms/i/s!AlQc3lJwQx7bgbAJQx-HsvGY8Gcqsg > > > > Anyone know where this wire should go? > > I believe you have 'my' schematic of the VR241. I think this wire is shown on > sheet 2 of the scan board diagram, (page > 7 of the .pdf file) just above C718. It's on the daughterboard that carries the > horizontal output transistor, and is fitted onto one of 2 pins on that board > labelled 'S' and 'L'. In one position it does nothing (so leaving it free would do > no harm provided it doesn't short to anything), in the other is short-circuits > C718. >
Yes I have your schematic and I had looked to see if I could see the wire but I had failed to spot it. Thanks for pointing it out. My worry was simply that I had not noted where it connected, but it seems it wasn't connected in the first place. Regards Rob
