On 5/29/16 11:34 AM, Mark J. Blair wrote: > My first attempt to use silicone tubing to repair my TU58 rollers was also > unsuccessful. Maybe the material I used is too soft? Your experience suggests > to me that I should hook up an oscilloscope to measure bit timing, and then > adjust the roller composition and diameter to arrive close to the correct bit > length. > >
dug this up from the cctlk archive -- http://www.usplastic.com/catalog/item.aspx?itemid=23485 It just says "norprene A-60-F" the outside. It measures 3/8" I.D. I think other's have said 7/16" i.d., but I could not find that. I know I bought it from US Plastics and it's A-60-F. You have to buy 10' but its not very expensive. -brad
