> > Well... > REM ...AT. worked since an AT entry was present in the TAL output > INS $BIGIND not > INS -- File not found > > Disk (RD51) has 850 blocks free after some cleaning up. It had 738 before.
> Thank for your answer. > I'll try your suggestions. > It's RSX-11 and I've found some troubles on the disk. > I ran VFY with the /RC option. > Some files can't be read (it reports -4 and -101 errors, parity error > and forced error mark). > INDEXF.SYS itself appears to have a bad spot. > So I'm tempted to backup all relevant data and reinstall. > > BTW there's no [3,54] on the fixed disk. Ok, if you don't have [3,54] then you must have RSX-11M not RSX-11M+. In that case you should have two versions of Indirect: [1,54]ICP.TSK [1,54]ICX.TSK ICP.TSK is the default, "full capacity" version and in V4.0 of RSX11M it shows up under TAS as: >TAS ...AT. ...AT. 1.0 GEN 64. 00060000 LB0:-00114253 so try removing it as you did above and then INS the ICX.TSK and try it. >REM …AT. >INS [1,54]ICX.TSK >TAS …AT. ...AT. 9.01 GEN 64. 00060000 LB0:-00114033 It would be good to know which version of RSX-11M you have and also a bit about the configuration. You mention backing up your data, what disks do you have? To back up a system disk sometimes it is best to use BRUSYS.SYS which on M should be in [1,51] It is a memory resident version of BRU (running under RSX11S) that you BOOT and then can copy disks. Good Luck! Mark