I've never used EagleCAD but some CAD packages let you turn off all routed lines
On Tue, Mar 29, 2016 at 5:25 PM, Paul Koning <paulkon...@comcast.net> wrote: > > > On Mar 29, 2016, at 8:18 PM, Guy Sotomayor <g...@shiresoft.com> wrote: > > > > I just finished laying out the board for the MEM11A. The last roadblock > was figuring out > > where the last 3 unrouted wires were. EagleCAD didn’t make it easy to > find them and I > > haven’t quite figured out how to use the autorouter on Eagle 7.5, so I > did this all by “hand” > > (at just under 2000 wires it took a while). > > I can imagine. Hand-routing tends to produce much better results; the > autorouter in EagleCAD isn't all that good. A simple way to find the not > yet routed wires is to turn off the metal layers but leave the "ratsnest" > layer visible. > > paul > > > >