The RL01/RL02 Users Guide (bitsavers.org/pdf/dec/disc/rl01_rl02) Figure 2-25 on page 2.35 describes the positioner restraining bracket that should be put in place before shipping. It is just a little square piece of metal (probably aluminum) with a single screw that holds it down that sits in front of the carriage to keep it from rolling into the pack area.
Of course, you don't want a pack in there while you are moving it around. :) It also mentions on that page a couple of shipping screws on the bottom of the drive to restrain the spindle/blower motor from turning. On 7/10/2015 11:11 PM, devin davison wrote: > I made a mistake. I was reading about the floppy drive and accidentally > mentioned the rx01 / rx02. The hardware to be moved is actually RL01/RL02 > hard drives, not the floppy drive. Please forgive the mix up, any help is > appreciated. >
