Mark J. Blair wrote: > > Since I can't seem to boot up my R80 or my other RL02 pack (labeled > "VMS53RL02SYS" on top) yet, I've been trying to bring up the VMS 5.3 > Standalone Backup tape images I found there. No luck so far. I have > never run a VMS Standalone Backup environment before, but I am blindly > hoping that it will be a small VMS environment that will let me try to > mount filesystems from my hard drives and see what, if anything, is on > them. I would greatly appreciate any clues here, because I'm in unknown > waters. >
Standalone backup is a very small VMS environment. You get a "$" prompt and the only command which it accepts is "BACKUP". You don't get to mount anything as BACKUP will perform any mounting needed itself. I'm not sure but it is also possible that only BACKUP /IMAGE works. The typical way to do a fresh VMS install onto a new disk is to boot standalone backup (from a tape or another disk) and then use it to restore the "B" saveset of the VMS distribution onto the target disk. Then boot the target disk and answer the questions. If you manage to get standalone backup running and want to try reading existing filesystems or distribution media without risking overwriting data you want to keep, you could try something like: $ BACKUP /IMAGE /LOG device: NLA0: With any luck, this should back up the files on "device" to the null device and list the filenames as it does it. If it complains, try this: $ BACKUP /IMAGE /LOG device: NLA0:SAVESET.BCK /SAVE_SET but that variation probably won't work for distribution media as that will be provied in saveset form and you can't have a saveset as both input and output. Regards, Peter Coghlan.
