My Advantage decided to stop booting from floppy disks (the only media it
is capable of booting). At first it threw random disk errors, then
progressed to the point where I get an immediate "Hardware Failure"
diagnostic on screen at power up. If I reset and hit 'Enter' it starts
the disk drive comes right back with a "?" prompt and LOAD SYSTEM.
I've checked the obvious:
- Power supply voltages are good
- Pulled, cleaned leads and re-seated 52 very tarnished 4116s
- Cleaned and reseated all other socketed parts.
A lot does seem to be working. Display is fine. I can enter the
mini-monitor and poke around. Keyboard is being read properly.
I accidentally found an undocumented diagnostic (enter mini-monitor with
Ctrl-C and enter 'A'). This displays the disk controller status
registers. The only activity is the sector mark pulse, so something is
responding to disk data.
Any advice from other Advantage owners or those familiar with the beast
would be appreciated.
Interesting data point: I replaced the 8035 slave processor with a newer
8035 from the parts bin and none of the I/O operations it manages worked
at all - no keyboard no disk activity. Is there perhaps something special
about the older part? I'm not aware of any major differences in this part
through the years, but you never know.
--
