On 2015-May-27, at 2:18 PM, Chuck Guzis wrote: > I did a little checking today--I compared a male 163-type receptacle with a > C14 receptacle. The mounting ear holes appear to have the same spacing; the > C14 is about 3/4" thick, where the 163 (metal shell) is about 1/2" thickness, > so you'd need to enlarge the mounting holes about 1/8" on the top and > bottom. The 163 is a bit wider, but not enough to matter--you'll have to > square off the hole corners, as the shell of a 163 is oval, not rectangular.
Oh, unfortunately the screw holes are not quite the same spacing, but it's possible to file them a fraction to the side on the chassis and still have good coverage and seating of the nut. See pic at bottom of page: http://www.cs.ubc.ca/~hilpert/e/powerConn/index.html > All in all, if done carefully, there's no indication that anyone could tell > if a modification had been made. Yup, I should take pics of the progressive stages when I do one sometime.
