I have processed my Data with XDS, here the completeness is 95.5% after
merging two data sets of the same crystals (initially it was 90% when was
not merged) at the scaling step and R-factor is 18.5 and I/sigma is 1.45.
and I further went with this data for molecular replacement where the
Z-value was found to be 13. and after running Refmac the Ractor was bad its
about 38.4 % then I runned the bucneer for Autobuilding and the FOM gone
higher from initial cycle 0.57 to 0.75 at resolution of 2.5 Angstrom. can
anybody suggest me what should I do for bringing my R factor lower and at
the better positon.
